Blade-Stand

Type HSG-GMN-V-E-K

leaflet  (pdf)

 

With our thermal cutting system it is possible to cut synthetic fabric, such as belts, bands and ropes to length. To make holes in belting fabric can also be provided on special request.

An electric heated blade separates, in one phase of operation,  the material by heat and seals the cut edges to avoid fringing of the cut edge.

 

For this functions we fabricate:

- Hand- and table-units with blade for manual use, 

  (see leaflet HEAT CUTTERS).

- Blade-stands semiautomatic

- Machines automatic

 

Our devices and machines are constructed in a mechanical assembly technique (MAT) and by this can be combined in many ways to meet our customers'individual needs.

 


 

 

 

Blade-Stand Type HSG-GMN-V-E-K

 

The smallest blade-stand has a straight blade, suction, protection cap, quick change system for the blade, plug in electric connection and separate heat transformer.

 

While the blade is moved manually with the smaller tools, it is done at the blade-stand by means of a pneumatic cylinder.

The fabric is placed under the blade or combined tool and the cutting operation is released through hand or foot actuation. Then the fabric is pulled on forward to the desired length-measure to be controlled with tape measure or adjustable limit Stop. With the following cut the firstsection is trimmed on both ends while the first edge of the next section is trimmed. This means, with each cycle, one section is completely trimmed.

 
Ratings:

Movement of the blade(s): Pneumatic.
Belt width: max. 50 mm.
Belt thicknesses: Max. 4mm.
Rope diameter: Max. 12mm Ø.
Cutting element: Electric direct heated blade. Heating time in approx. 1 minute to 600°C.
Temperature: 100 - 600°C, infinitely variable.
Voltage: 230 Volt - 50/60Hz (110Volt -60Hz).
Power input: 800 VA.
Air pressure: 6 bar.
Dimensions: approx. 120 x 300 x 240 mm (b x h x t).
Weight: approx. 12 kg, with heating transformer.